260 1201 Cable extension 2mCable 3*0.5mm2, very resistant, halogen-free and with
2 quick couplings.
– 1 plug for nSens-HT / nSens-T sensor
– 1 plug to nSens cable Cable plug
Electrolytic measurement technology for highest demands
Digital Humidity & Temperature Sensor with Electrolytic Humidity Sensor & NTC Temperature Measurement.
Includes 5 points factory certificate and
nCap-PS Protective filter cap.
The adjustment points are stored directly in the sensor.
Sensor is pluggable and can be exchanged very quickly and easily.
Power supply: 5-12V DC
Outputs: Modbus RTU
Modbus allows the reading of all climate and diagnostic data of the connected nSens sensors.
Technical description / Modbus register on novasina.ch
Configuration of the adapter via Modbus or nCom485 set (260 1125).
To connect the nLink-Modbus adapter to the Modbus network
Compatible with all nSens sensors and nSens cables
Conversion adapter from nSens sensor to bus input of the ClimMate.
Attention : for each nSens sensor 1 nLink-UMB is required for connection.
Set for mounting nSens sensors on walls or channels, incl. screws.
The duct flange seals up to a pressure of
3 bar off!
For wall distance up to center 20mm for different sensor types.
Wall mounting material is supplied.
Windows based software for calibration and adjustment of nSens probes on the PC. Runs on Windows 98/2000/XP/Vista/Windows 7 and 8.
Ready to use and reusable as often as required when stored correctly.
Shelf life 5 years (with correct storage)
Humidity standards based on saturated salt solutions in plastic cylinders, with moisture-permeable membrane.
Consult the instruction manual of the instrument to see which points can be adjusted. The other SAL-SC can be used for calibration.
111 7847-case set with SAL-SC 111 7841-case without contents
– for all sensor types up to 17mm
Plastic adapter for humidity standards as reduction piece and radial seal on the circumference of the respective sensor.
Styrobox for temperature stabilization of a SAL-SC check during adjustment. Box consisting of 2 half shells,
which are mounted around the SAL-SC cylinder.
Factory certificates for nSens-HT-CSS must be provided if required.
nSens-HT-ENS contain the factory certificate at 5 points (111 2874) in the scope of delivery.
Sensors can be recalibrated and adjusted at any time.
Thank you for your interest in our products.
Do you have questions or concerns about the applications or the product?
Please use our contact form to contact us. We will deal with your request as soon as possible and get back to you by mail or phone.